ТРОС МЕХАНИЗМА ПЕРЕКЛЮЧЕНИЯ ПЕРЕДАЧ СНЯТИЕ

PROCEDURE


  1. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

    Click here

  2. DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

    A01CX5OC01
    *1 Select Control Cable
    *2 Shift Control Cable

    1. Remove the clip and disconnect the cable end of the select control cable from the floor shift shift lever assembly.

    2. Push the ends of the clip apart, and then disconnect the shift control cable from the floor shift shift control cable assembly.

    3. A01CYF4C01
      *1 Cable Lock
      *2 Lock Nut

      Using a screwdriver, pull out the cable locks of the shift control cable and select control cable.

    4. Rotate the nut clockwise approximately 180° and, while holding the nut in that position, disconnect the shift control cable and select control cable from the floor shift shift lever assembly.

      Note

      Do not over-rotate the cable lock as it will come off the internal spring and the transaxle control cable assembly will not be reusable.

    5. Remove the shift control cable from the floor shift lever assembly while holding the lock nut.

  3. REMOVE FRONT FLOOR COVER

    Click here

  4. REMOVE AIR CLEANER BRACKET

    Click here

  5. DISCONNECT ENGINE WIRE

    A01CXIA

    1. Remove the bolt, clamp and engine wire.

  6. REMOVE TRANSAXLE CONTROL CABLE ASSEMBLY

    A01CWKCC01
    *1 Select Control Cable
    *2 Shift Control Cable

    1. Removal the 2 clips and disconnect the top ends of the transaxle control cable assembly from the manual transaxle assembly.

    2. Remove the 2 clips and disconnect the control cable bracket.

    3. A01CWM3

      Remove the 2 bolts from the retainer.

    4. Pull out the transaxle control cable assembly from the floor.