РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с 2WW) УСТАНОВКА

PROCEDURE


  1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY


    1. A01VAU7

      Install the clutch release cylinder assembly with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

  2. CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE


    1. A01V7LMC01
      *a Torque Wrench Fulcrum Length

      Using a 10 mm union nut wrench, connect the clutch release cylinder to flexible hose tube.

      Torque:
      Specified tightening torque
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.2 N*m (135 kgf*cm, 10 ft.*lbf)

  3. BLEED CLUTCH LINE

    Click here

  4. CHECK FOR BRAKE FLUID LEAKAGE

    Click here

  5. INSTALL NO. 1 AIR TUBE ASSEMBLY

    Click here

  6. CONNECT NO. 2 AIR HOSE

    Click here

  7. INSTALL NO. 4 WATER BY-PASS HOSE

    Click here

  8. CONNECT ENGINE WIRE

    Click here

  9. CONNECT COMPRESSOR OUTLET ELBOW

    Click here

  10. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  11. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY

    Click here

  12. INSTALL BATTERY BRACKET REINFORCEMENT

    Click here

  13. INSTALL BATTERY CARRIER ASSEMBLY

    Click here

  14. INSTALL BATTERY TRAY

  15. INSTALL BATTERY

  16. INSTALL BATTERY INSULATOR

  17. INSTALL BATTERY CLAMP SUB-ASSEMBLY

    Click here

  18. CONNECT CABLE TO POSITIVE BATTERY TERMINAL

  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  20. ADD ENGINE COOLANT

    Click here

  21. INSPECT FOR COOLANT LEAK

    Click here

  22. INSTALL NO. 1 ENGINE UNDER COVER

    Click here