РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с 2WW) ПОВТОРНАЯ СБОРКА

PROCEDURE


  1. INSTALL RELEASE CYLINDER BLEEDER PLUG


    1. Install the release cylinder bleeder plug to the release cylinder body.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

    2. Install the bleeder plug cap to the release cylinder bleeder plug.

  2. INSTALL CLUTCH RELEASE CYLINDER KIT


    1. A01QPRQ

      Coat a new piston with lithium soap base glycol grease as shown in the illustration.

    2. Install the piston and a new spring to the release cylinder body.

      Note

      Do not damage the inside of the release cylinder body.

      Tech Tips

      Install the maller end of the spring to the piston.

    3. Install a new boot to the push rod.

    4. Install the push rod together with the boot to the release cylinder body.