СИСТЕМА СЦЕПЛЕНИЯ (для моделей с 2WW) ПРОКАЧКА

CAUTION / NOTICE / HINT

Note

Wash off clutch fluid immediately if it comes in contact with any painted surface.

Tech Tips

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

PROCEDURE


  1. REMOVE COWL TOP VENTILATOR LOUVER BRACKET LH

    Click here

  2. FILL BRAKE FLUID RESERVOIR


    1. Remove the brake master cylinder reservoir filler cap assembly.

    2. Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.

      Brake fluid
      SAE J1704 or FMVSS No. 116 DOT 4

      Note

      Do not remove the filter from the brake master cylinder reservoir and be sure to fill with new brake fluid to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.

  3. BLEED CLUTCH LINE


    1. Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brake.

      Brake fluid
      SAE J1704 or FMVSS No, 116 DOT 4
    2. A01QT9ZC03
      *1 Bleeder Plug Cap
      *2 Bleeder Plug

      Remove the bleeder plug cap.

    3. Connect a vinyl tube to the bleeder plug.

    4. Depress the clutch pedal several times, and then loosen the bleeder plug while the pedal is depressed.

    5. When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal.

    6. Repeat the previous 2 steps until all the air in the fluid is completely bled.

    7. Tighten the bleeder plug.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

    8. Install the bleeder plug cap.

    9. Check that all the air has been bled from the clutch line.

  4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

    Click here

  5. INSTALL COWL TOP VENTILATOR LOUVER BRACKET LH

    Click here