РЕЛЕ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. INSPECT GLOW PLUG RELAY ASSEMBLY


    1. A01QO6I

      Disconnect the glow plug relay connector.

    2. Detach the clamp and remove the glow plug relay.

    3. A01QP76N01

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Battery voltage not applied to terminals 3 and 4 10 kΩ or higher
        Battery voltage applied to terminals 3 and 4 Below 1 Ω

        If the result is not as specified, replace the glow plug relay assembly.

  2. INSPECT STRTER RELAY (ST)


    1. A01QUEBN01

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the ST NO. 1 relay.