ДАТЧИК ДАВЛЕНИЯ МАСЛА СНЯТИЕ

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link Replacement of oil pressure sensor Reset memory Deceleration sensor zero point calibration CVT oil pressure calibration DTC P1589 is output (Malfunction Indicator Lamp (MIL) not iilluminated) Deterioration of fuel efficiency Click here

PROCEDURE

1. REMOVE FRONT WHEEL LH

2. REMOVE REAR ENGINE UNDER COVER LH

   Click here

3. REMOVE OIL PRESSURE SENSOR

   

   
   

   1. Disconnect the oil pressure sensor connector.

   2. 

      Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

      SST

      09326-22011