ВПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

CAUTION / NOTICE / HINT

Note


  • When replacing the injectors (including shuffling the injectors between the cylinders), common rail, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.

  • When replacing the fuel supply pump, common rail, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE DIESEL THROTTLE BODY ASSEMBLY

    Click here

  4. DISCONNECT ENGINE WIRE

    Click here

  5. REMOVE EGR VALVE BRACKET

    Click here

  6. REMOVE NO. 7 WATER BY-PASS HOSE


    1. B0029C5

      Slide the clamp and remove the No. 7 water by-pass hose from the electric EGR control valve assembly.

  7. DISCONNECT NO. 8 WATER BY-PASS HOSE

    Click here

  8. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY

    Click here

  9. REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY

    Click here

  10. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

    Click here

  11. REMOVE INJECTION PIPE SUB-ASSEMBLY

    Click here

  12. REMOVE COMMON RAIL ASSEMBLY

    Click here

  13. REMOVE INTAKE MANIFOLD INSULATOR


    1. B002AC0

      Remove the intake manifold insulator from the intake manifold.

  14. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. Remove the engine oil level dipstick.

    2. B0029SD

      Disconnect the connector and detach the wire harness clamp from the engine oil level dipstick guide.

    3. Remove the 2 bolts and engine oil level dipstick guide.

    4. Remove the O-ring from the engine oil level dipstick guide.

  15. REMOVE DIESEL TURBO PRESSURE SENSOR

    Click here

  16. REMOVE NO. 1 GAS FILTER


    1. B0029TV

      Disconnect the vacuum hose.

    2. Remove the No. 1 gas filter from the gas filter bracket.

  17. REMOVE GAS FILTER BRACKET


    1. B002ABM

      Remove the 2 bolts and gas filter bracket.

  18. REMOVE ENGINE COVER BRACKET


    1. B0029EQ

      Remove the bolt and engine cover bracket.

  19. REMOVE NO. 2 INTAKE MANIFOLD


    1. B002984

      Remove the bolt, 2 nuts, No. 2 intake manifold and gasket.

  20. DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY


    1. B002AKY

      Slide the clamp and disconnect the No. 2 vacuum transmitting hose assembly from the intake manifold.

  21. REMOVE INTAKE MANIFOLD


    1. B002ADQC02
      *1 Nut

      Remove the 7 bolts, 2 nuts, intake manifold and gasket.

  22. REMOVE STUD BOLT

    Tech Tips

    If a stud bolt is deformed or the threads are damaged, replace it.