ДАТЧИК ТЕМПЕРАТУРЫ ОТРАБОТАВШИХ ГАЗОВ (для датчика 1) УСТАНОВКА

PROCEDURE


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1)


    1. A01V6YVC01
      *a Torque Wrench Fulcrum Length

      Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      Specified tightening torque
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      If the exhaust gas temperature sensor is dropped, replace it with a new one.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)

  2. INSTALL NO. 1 TURBO INSULATOR


    1. Install the No. 1 turbo insulator with the 3 bolts and nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. CONNECT VACUUM CONTROL VALVE BRACKET


    1. Using a T20 "TORX" socket wrench, connect the vacuum control valve bracket with the 3 screws.

    2. Attach the air fuel ratio sensor clamp to the vacuum control valve bracket.

    3. A01V96NC01
      *1 Vacuum Control Valve Bracket
      *a 1.5 mm (0.0591 in.) or less
      *b Air Fuel Ratio Sensor Connector Wire
      *c Exhaust Gas Temperature Sensor Connector Wire
      *d Air Fuel Ratio Sensor Connector

      Move the clamp as shown in the illustration, and secure the air fuel ratio sensor and exhaust gas temperature sensor with the clamp.

      Note

      The wire harness may become damaged if not installed when the clamp is open.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)

    4. Lower the air fuel ratio sensor connector to the position shown in the illustration.

    5. Connect the air fuel ratio sensor connector.

    6. Connect the exhaust gas temperature sensor connector.

    7. Attach the wire harness clamp.

    8. Connect the exhaust gas temperature sensor connector.

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here

  5. INSTALL NO. 1 ENGINE COVER

    Click here