ДИФФЕРЕНЦИАЛЬНЫЙ ДАТЧИК ДАВЛЕНИЯ ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE


  1. CHECK DIFFERENTIAL PRESSURE SENSOR


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Adaptation Value of Differential Pressure at Particle Filter.


      Powertrain > Engine and ECT > Data List
      Tester Display
      Adaptation Value of Differential Pressure at Particle Filter

    5. Disconnect the No. 1 vacuum transmitting hose from the differential pressure sensor.

    6. A01M2B1C01
      A01M03W Pressure

      Using SST, apply pressure to the differential pressure sensor.

      SST
      09992-00242

    7. Check the pressure value of the differential pressure sensor.

      Standard Pressure
      Approximately the same pressure as the applied pressure is indicated on the GTS.

      Note

      Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

      If the result is not as specified, check the differential pressure sensor circuit.

      Click here

    8. Connect the No. 1 vacuum transmitting hose to the differential pressure sensor.