ТОПЛИВНАЯ СИСТЕМА ДВИГАТЕЛЯ COMMON RAIL УСТАНОВКА

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL PRESSURE DISCHARGE VALVE ASSEMBLY

   Click here

2. INSTALL FUEL PRESSURE SENSOR

   Click here

3. INSTALL COMMON RAIL ASSEMBLY

   
   

   1. Install the common rail assembly to the cylinder head cover sub-assembly.

   2. Using an E10 "TORX" socket wrench, install the 2 common rail assembly brackets with the 4 bolts.

      Tech Tips

      Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.

   3. Connect the fuel return tube.

   4. Connect the pressure discharge valve assembly connector.

   5. Connect the fuel pressure sensor connector.

4. INSTALL FUEL INLET PIPE SUB-ASSEMBLY

   Note

   
   

   • If the pressure lines are leaking after installation, they must be replaced.

   • Do not overtighten the pressure lines.

   
   
   1. 

      *1	Rubber Grommet
      *2	Rubber Mount

      Install the fuel inlet pipe sub-assembly to the rubber grommet and rubber mount shown in the illustration.

      Note

      Install the rubber mount and rubber grommet at the correct positions on the pressure line.

   2. Temporarily install the union nuts at the fuel supply pump assembly end and common rail assembly end of the fuel inlet pipe sub-assembly by hand.

   3. Using SST, tighten the union nuts at the fuel supply pump assembly end and common rail assembly end of the fuel inlet pipe sub-assembly in the order shown in the illustration.

      SST
      PZ4TB-04959-10

      Torque:

      24 N*m  { 245 kgf*cm, 18 ft.*lbf }

      Note

      Reset SST in a timely manner to prevent bending of pressure lines.

5. INSTALL INJECTION PIPE SUB-ASSEMBLY

   Click here

6. INSTALL INTAKE MANIFOLD

   Click here

7. INSPECT FOR FUEL LEAK

   Click here