ТОПЛИВНЫЙ НАСОС СНЯТИЕ

PROCEDURE


  1. REMOVE FUEL TANK

    Click here

  2. DISCONNECT FUEL EMISSION HOSE


    1. A01GAAMC01
      *1 No. 1 Fuel Evaporation Tube Sub-assembly
      *2 Charcoal Canister Outlet Tube Sub-assembly
      *3 Fuel Emission Hose
      *4 Retainer

      Slide the 2 clamps and disconnect the No. 1 fuel evaporation tube sub-assembly and charcoal canister outlet tube sub-assembly from the fuel suction plate.

    2. Pinch the retainer as shown in the illustration, and then disconnect the fuel emission hose from the fuel suction plate.

      Note


      • Clean off any dirt and foreign matter from the clip before disconnecting the hoses.

      • Do not use any tools in this procedure.

      • Do not forcefully bend or twist the nylon tube.

      • Put the hose in a plastic bag to prevent damage and contamination.

      • If the connector is stuck, pinch the retainer and push and pull the hose to disconnect it.

  3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY


    1. A01GBH6

      Remove the tube joint clip and fuel tank main tube sub-assembly.

      Note


      • Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.

      • Keep the O-ring free of foreign matter, as it becomes contaminated easily.

      • Do not use any tools in this procedure.

      • Do not forcefully bend or twist the tube.

      • Put the tube in a plastic bag to prevent damage and contamination.

      • If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.

      • Be careful not to damage the clip. If the clip is damaged, replace it.

  4. REMOVE FUEL TANK VENT TUBE SET PLATE


    1. A01GBU4

      Remove the 8 bolts and fuel tank vent tube set plate.

  5. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP


    1. A01GCYG

      Slide the clamp and disconnect the fuel hose and remove the fuel suction with pump from the fuel tank assembly.

      Note

      Do not damage the fuel suction tube assembly with pump.

    2. A01GAXSC01
      *1 Gasket

      Remove the gasket from the fuel suction tube assembly with pump.