ПЕРЕДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE

1. Click here

   INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

   
   
   1. 

      Using an 8 mm hexagon wrench, install SST (A) to the crankshaft.

      SST
      PZ4TB-04961-27

   2. Set a new timing gear case or timing chain case oil seal to the cylinder block.

   3. 

      Install SST (B) to SST (A).

      SST
      PZ4TB-04961-27

   4. 

      Install and tighten SST (C) to install the timing gear case or timing chain case oil seal to the crankshaft.

      SST
      PZ4TB-04961-27

      Tip:

      Tighten SST (C) until SST (B) contacts the cylinder block.

   5. Remove SST (C), SST (B) and SST (A).

2. Click here

   INSTALL CRANKSHAFT PULLEY

   
   
   1. 

      Using SST, hold the flywheel sub-assembly.

      SST
      PZ4TB-04951-26

   2. Install the crankshaft pulley to the crankshaft with 4 new bolts.

      Tip:

      The crankshaft pulley bolts are tightened in 2 progressive steps.

   3. Step 1:

      
      

      1. Using an E10 "TORX" socket wrench, tighten the 4 bolts.

         40 N*m	408 kgf*cm	30 ft.*lbf

   4. Step 2:

      
      

      1. Mark the RH side of each crankshaft pulley bolt with paint.

      2. Tighten the bolts 120°.

      3. Check that the paint marks are now at a 120° angle to the RH side.

   5. Remove SST.

   6. Install the plug to the cylinder block.

3. Click here

   INSTALL V-RIBBED BELT

   Click here