СТАРТЕР СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY INSULATOR

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. REMOVE FRONT BATTERY BRACKET

    Click here

  11. REMOVE BATTERY BRACKET REINFORCEMENT

    Click here

  12. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  13. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  14. REMOVE AIR CLEANER CASE

    Click here

  15. REMOVE AIR CLEANER SUPPORT

    Click here

  16. DISCONNECT FUEL FILTER ASSEMBLY


    1. A00YX3J

      Remove the bolt and disconnect the fuel filter assembly.

  17. REMOVE AIR CLEANER BRACKET

    Click here

  18. REMOVE NO. 1 AIR TUBE


    1. A00YSNZ

      Remove the bolt and detach the clamp.

    2. A00YTFB

      Detach the 2 clamps.

    3. A00YVQT

      Remove the 2 bolts and loosen the 2 clamps.

    4. Remove the No. 1 air tube.

  19. REMOVE NO. 3 AIR HOSE

    Click here

  20. REMOVE STARTER ASSEMBLY


    1. A00YT4M

      Disconnect the starter connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. A00YSIU

      Remove the 2 bolts and starter assembly.