ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ

PROCEDURE


  1. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

    Click here

  2. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)

    Click here

  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A01V7HKN08

      Using SST, hold the crankshaft.

      SST
      09213-54015

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01VA6S

      Remove the 8 bolts and flywheel sub-assembly.

  6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)


    1. A01V7HKN08

      Using SST, hold the crankshaft.

      SST
      09213-54015

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A01V7UE

      Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly, and the front drive plate spacer.

  7. REMOVE ENGINE REAR OIL SEAL


    1. A01V82VC08
      *1 Cut Position
      *2 Protective Tape

      Using a knife, cut off the lip of the engine rear oil seal.

    2. Using a screwdriver with its tip wrapped with tape, pry out the engine rear oil seal.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the engine rear oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.