БЛОК ЦИЛИНДРОВ ЗАМЕНА

PROCEDURE


  1. REPLACE CYLINDER BLOCK STRAIGHT PIN

    Note

    It is not necessary to remove the cylinder block straight pin unless it is being replaced.


    1. Remove the cylinder block straight pin.

    2. Using a plastic-faced hammer, tap in a new cylinder block straight pin to the cylinder block sub-assembly.

      Standard Protrusion
      Item Specified Condition
      Pin A 11 mm (0.433 in.)
      Pin B 7.0 mm (0.726 in.)
      Pin C 18 mm (0.709 in.)
      Pin D 7.5 mm (0.725 in.)
      Pin E 7.5 mm (0.725 in.)
      A00YW1ZC01
      *a Rear Side *b Upper Side
      *c Lower Side *d Front Side
      *e Crankshaft Bearing Cap Exhaust Side - -
    3. A00YU0I

      Using a plastic-faced hammer, tap in new cylinder block ring pins to the crankshaft bearing cap.

      Standard protrusion
      6.5 mm (0.256 in.)