ДВИГАТЕЛЬ В СБОРЕ УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *1 | DIFFERENTIAL PRESSURE SENSOR ASSEMBLY | *2 | FRONT FLOOR COVER |
| *3 | FRONT FLOOR COVER RH | *4 | NO. 1 ENGINE COVER |
| *5 | NO. 1 ENGINE UNDER COVER | *6 | NO. 2 ENGINE UNDER COVER |
| *7 | REAR ENGINE UNDER COVER LH | *8 | REAR ENGINE UNDER COVER RH |
| *9 | VACUUM TRANSMITTING HOSE | - | - |
 |
N*m (kgf*cm, ft.*lbf) : Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | GASKET |
| *3 | COMPRESSION SPRING | *4 | TAILPIPE ASSEMBLY |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *1 | AIR CLEANER CAP SUB-ASSEMBLY | *2 | AIR CLEANER CASE |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY BRACKET REINFORCEMENT | *6 | BATTERY CLAMP SUB-ASSEMBLY |
| *7 | BATTERY INSULATOR | *8 | BATTERY TRAY |
| *9 | NEGATIVE BATTERY TERMINAL | *10 | POSITIVE BATTERY TERMINAL |
| *11 | FRONT BATTERY BRACKET | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | AIR CLEANER BRACKET | *2 | AIR CLEANER SUPPORT |
| *3 | DISCHARGE HOSE SUB-ASSEMBLY | *4 | FUEL FILTER ASSEMBLY |
| *5 | FUEL HOSE PROTECTOR | *6 | INLET HEATER WATER HOSE |
| *7 | NO. 2 RADIATOR HOSE | *8 | NO. 2 WATER BY-PASS HOSE |
| *9 | NO. 3 AIR HOSE | *10 | OUTLET HEATER WATER HOSE |
| *11 | SUCTION HOSE SUB-ASSEMBLY | *12 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| *13 | PIN | *14 | O-RING |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent | - | - |
ILLUSTRATION
| *1 | CLUTCH RELEASE CYLINDER ASSEMBLY | *2 | ECM |
| *3 | NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY | *4 | RADIATOR HOSE SUB-ASSEMBLY |
| *5 | RADIATOR RESERVOIR ASSEMBLY | *6 | ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK COVER |
| *7 | INJECTOR DRIVER ASSEMBLY | - | - |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |
ILLUSTRATION
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | FRONT AXLE SHAFT NUT LH |
| *3 | FRONT DRIVE SHAFT ASSEMBLY LH | *4 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *5 | FRONT STABILIZER LINK ASSEMBLY LH | *6 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *7 | FRONT SPEED SENSOR LH | *8 | TIE ROD END SUB-ASSEMBLY LH |
| *9 | FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH | *10 | FRONT DRIVE SHAFT HOLE SNAP RING LH |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| |
MP grease |  |
Do not apply lubricants to the threads |
ILLUSTRATION
| *A | for 2WD | *B | for 4WD |
| *1 | ENGINE MOUNTING BRACKET LH | *2 | FRONT LOWER ENGINE MOUNTING BRACKET REINFORCEMENT |
| *3 | FRONT SUSPENSION MEMBER REINFORCEMENT LH | *4 | FRONT SUSPENSION MEMBER REINFORCEMENT RH |
| *5 | NO. 1 ENGINE HANGER | *6 | NO. 2 ENGINE HANGER |
| *7 | REAR ENGINE MOUNTING INSULATOR | *8 | FRONT SUSPENSION MEMBER REAR BRACE RH |
| *9 | FRONT SUSPENSION MEMBER SUB-ASSEMBLY | *10 | FRONT SUSPENSION MEMBER REAR BRACE LH |
| *11 | FRONT ENGINE MOUNTING INSULATOR | *12 | FRONT CROSSMEMBER SUB-ASSEMBLY |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ★ | Precoated part |
ILLUSTRATION
| *A | for 2WD | *B | for 4WD |
| *1 | CLUTCH COVER ASSEMBLY | *2 | CLUTCH DISC ASSEMBLY |
| *3 | FLYWHEEL WITH DAMPER ASSEMBLY | *4 | FRONT ENGINE MOUNTING BRACKET |
| *5 | INTERCOOLER AIR HOSE | *6 | MANUAL TRANSAXLE ASSEMBLY |
| *7 | NO. 1 AIR TUBE | *8 | OIL PAN INSULATOR |
| *9 | REAR ENGINE MOUNTING BRACKET | *10 | STARTER ASSEMBLY |
| *11 | STIFFENER PLATE LH | *12 | STIFFENER PLATE RH |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
ILLUSTRATION
| *1 | ENGINE MOUNTING INSULATOR LH | *2 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
| |
Specified torque: N*m (kgf*cm, ft.*lbf) | - | - |