ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE MANUAL TRANSAXLE ASSEMBLY


  4. REMOVE CLUTCH COVER ASSEMBLY

    Click here

  5. REMOVE CLUTCH DISC ASSEMBLY

    Click here

  6. REMOVE FLYWHEEL WITH DAMPER ASSEMBLY

    Click here

  7. REMOVE REAR ENGINE OIL SEAL


    1. A01KDCKC04
      *1 Cut Position
      *2 Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note


      • Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      • After removing the rear engine oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.