ПРИВОДНОЙ РЕМЕНЬ СНЯТИЕ

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER RH


    1. A01GCYY

      Remove the 2 clips and rear engine under cover RH.

  3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01GBZH

      Remove the 4 bolts and front suspension member reinforcement RH.

  4. REMOVE FAN AND GENERATOR V BELT


    1. A01GBVDN01

      Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner pulley counterclockwise to loosen the fan and generator V belt tension. Then remove the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note

      Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.