МАСЛЯНЫЙ НАСОС УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *1 | AIR TUBE | *2 | FUEL DELIVERY PIPE SUB-ASSEMBLY |
| *3 | FUEL INJECTOR ASSEMBLY | *4 | FUEL TUBE SUB-ASSEMBLY |
| *5 | INTAKE MANIFOLD | *6 | THROTTLE BODY ASSEMBLY |
| *7 | WIRE HARNESS CLAMP BRACKET | *8 | INTAKE MANIFOLD STAY |
| *9 | GASKET | *10 | NO. 1 DELIVERY PIPE SPACER |
| *11 | O-RING | *12 | INJECTOR VIBRATION INSULATOR |
| *13 | NO. 2 FUEL PIPE CLAMP | - | - |
| *a | for Type A | *b | for Type B |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | EXHAUST MANIFOLD | *2 | MANIFOLD STAY |
| *3 | NO. 1 EXHAUST MANIFOLD HEAT INSULATOR | *4 | EXHAUST MANIFOLD GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | VACUUM PUMP ASSEMBLY | *2 | UNION TO CHECK VALVE HOSE |
| *3 | NO. 2 O-RING | *4 | NO. 3 O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Engine Oil | - | - |
ILLUSTRATION
| *1 | ENGINE OIL LEVEL DIPSTICK GUIDE | *2 | IGNITION COIL ASSEMBLY |
| *3 | NO. 1 VACUUM PUMP BRACKET | *4 | NO. 3 WATER BY-PASS HOSE |
| *5 | PCV HOSE | *6 | V-RIBBED BELT TENSIONER ASSEMBLY |
| *7 | WATER INLET HOSE | *8 | NO. 1 WATER BY-PASS PIPE |
| *9 | GASKET | *10 | ENGINE OIL LEVEL DIPSTICK |
| *11 | O-RING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CYLINDER HEAD COVER GASKET | *2 | CYLINDER HEAD COVER SUB-ASSEMBLY |
| *3 | SEAL WASHER | *4 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CRANKSHAFT PULLEY | *2 | ENGINE MOUNTING BRACKET STUD BOLT |
| *3 | NO. 1 CHAIN TENSIONER ASSEMBLY | *4 | OIL FILTER SUB-ASSEMBLY |
| *5 | THERMOSTAT | *6 | TIMING CHAIN COVER OIL SEAL |
| *7 | TIMING CHAIN COVER SUB-ASSEMBLY | *8 | WATER INLET |
| *9 | GASKET | *10 | O-RING |
| *11 | BRACKET | *12 | ENGINE WATER PUMP ASSEMBLY |
| *13 | SEAL WASHER | *14 | ENGINE MOUNTING BRACKET RH |
| *15 | OIL FILTER BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
MP grease |  |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
| ★ | Precoated part |  |
Do not apply lubricants to the threads |
ILLUSTRATION
| *1 | CHAIN SUB-ASSEMBLY | *2 | CHAIN TENSIONER SLIPPER |
| *3 | CRANKSHAFT TIMING SPROCKET | *4 | NO. 1 CHAIN VIBRATION DAMPER |
| *5 | NO. 2 CHAIN SUB-ASSEMBLY | *6 | O-RING |
| *7 | OIL PUMP DRIVE GEAR | *8 | OIL PUMP DRIVE SHAFT GEAR |
| *9 | CHAIN DAMPER SPRING | *10 | CHAIN TENSIONER PLATE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | NO. 2 OIL PAN SUB-ASSEMBLY | *2 | OIL PUMP ASSEMBLY |
| *3 | OIL PAN DRAIN PLUG | *4 | GASKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | OIL PUMP COVER SUB-ASSEMBLY | *2 | OIL PUMP RELIEF VALVE |
| *3 | OIL PUMP BODY | *4 | OIL PUMP DRIVEN ROTOR |
| *5 | OIL PUMP DRIVE ROTOR | *6 | OIL PUMP RELIEF VALVE SPRING |
| *7 | OIL PUMP RELIEF VALVE PLUG | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |