КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ СНЯТИЕ

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01QUKW

      Hold the rear of the No. 2 cylinder head cover and raise it to detach the 2 clips on the rear of the No. 2 cylinder head cover. Continue to raise the No. 2 cylinder head cover to detach the 2 clips on the front of the No. 2 cylinder head cover and remove the No. 2 cylinder head cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the No. 2 cylinder head cover to break.

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01QONB

      Disconnect the mass air flow meter connector.

    2. Detach the wire harness from the air cleaner cap sub-assembly.

    3. A01QOJ4

      Disconnect the 2 clamps.

    4. A01QPOQ

      Slide the clamp and disconnect the PCV hose from the cylinder head cover sub-assembly.

    5. Lock the air cleaner cap sub-assembly hose clamp, and then remove the air cleaner cap sub-assembly.

  5. REMOVE THROTTLE BODY ASSEMBLY


    1. A01QUMV

      Disconnect the throttle body assembly connector.

    2. Slide the 2 clamps and disconnect the water by-pass hose and No. 2 water by-pass hose.

    3. A01QRXY

      for Type A:

      Remove the 2 bolts, 2 nuts and throttle body assembly.

    4. for Type B:

      Remove the 4 bolts and throttle body assembly.

    5. Remove the gasket from the intake manifold.