ECM СНЯТИЕ

PROCEDURE


  1. PERFORM REGISTRATION

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01VAY9

      Disconnect the mass air flow meter connector and detach the wire harness clamp.

    2. Detach the 2 clamps.

    3. Loosen the hose clamp and remove the air cleaner cap sub-assembly.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01V8TZ

      Remove the 3 bolts and air cleaner case sub-assembly.

  7. REMOVE ECM


    1. A01V7BOC01
      A01V9RL Push
      A01V8SA Raise

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. A01V9MH

      Detach the claw and disconnect the relay.

    3. Remove the 3 bolts and ECM.

      Note

      Avoid physical shock to the ECM.

    4. A01VA3Y

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

    5. A01V7PL

      Remove the 2 screws and No. 2 ECM bracket from the ECM.