КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ ДИЗЕЛЬНОГО ДВИГАТЕЛЯ СНЯТИЕ

PROCEDURE


  1. REMOVE RADIATOR ASSEMBLY

    Click here

  2. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01V8YY

      Detach the 2 clamps.

    2. A01VB3PN01

      Using a T27 "TORX" socket wrench, remove the 2 bolts (A).

    3. Remove the bolt (B) and wire harness clamp bracket.

  3. REMOVE NO. 3 AIR HOSE


    1. A01V8T1

      Loosen the hose clamp and remove the No. 3 air hose from the air tube assembly.

  4. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    1. A01V6UIC01
      *1 Water By-pass Hose Assembly
      *2 Radiator Hose Sub-assembly

      Disconnect the water by-pass hose assembly and radiator hose sub-assembly from the air tube assembly.

    2. A01V72Q

      Detach the 2 wire harness clamps.

    3. A01VB0J

      Disconnect the intake air temperature sensor connector.

    4. A01V77H

      Disconnect the No. 7 engine wire connector and detach the clamp.

    5. A01V8M1

      Using a T27 "TORX" socket wrench, remove the bolt and disconnect the air tube assembly from the cylinder block sub-assembly.

    6. A01V8FH

      Using an E8 "TORX" socket wrench, remove the 3 bolts, diesel throttle body assembly with air tube assembly and gasket from the intake manifold.

      Note

      Avoid physical shock to the diesel throttle body assembly.

    7. Detach the 2 claws and remove the air tube assembly from the diesel throttle body assembly.

    8. Remove the gasket from the air tube assembly.

    9. A01V99Y

      Disconnect the diesel throttle body assembly connector.