ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note


      • When reusing the camshaft position sensor, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

    2. A00YWB6C01
      *1 Protrusion

      Install the crankshaft position sensor with the bolt.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

    3. Install the crankshaft position sensor wire harness with the clip.

      Note

      Make sure the crankshaft position sensor wire harness is installed in the position shown in the illustration.

    4. Install the harness clamp bracket with the bolt.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

    5. Connect the crankshaft position sensor connector.

  2. INSTALL GENERATOR ASSEMBLY

    Click here