ЧАШКА ЗАДНЕГО ДИФФЕРЕНЦИАЛА В СБОРЕ (для моделей с 2GR-FSE) УСТАНОВКА

PROCEDURE


  1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Note


    • Do not damage the installation surface when installing the rear differential carrier assembly.

    • The remaining oil may leak out when installing the rear differential carrier assembly.

    • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

    • Install the bolts with the rear differential carrier assembly secured.


    1. A01MXJNN02

      Support the rear differential carrier assembly with a jack.

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

    2. Install the 2 rear upper differential mount stoppers to the rear differential carrier assembly.

    3. Temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with the 2 rear lower differential mount stoppers and 2 new bolts (A).

    4. Using a 12 mm hexagon wrench, temporarily install the rear differential carrier assembly to the rear suspension member sub-assembly with 3 new bolts (B).

    5. Using a 12 mm hexagon wrench, tighten the 3 bolts (B).

      Torque:
      103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

    6. Tighten the 2 bolts (A).

      Torque:
      95.1 N*m  { 970 kgf*cm, 70 ft.*lbf }

      Note

      Do not tilt the inner tube or rubber parts when tightening the bolt (B).

  2. CONNECT TAIL EXHAUST PIPE LH

    Click here

  3. CONNECT TAIL EXHAUST PIPE ASSEMBLY

    Click here

  4. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

    Click here

  5. INSTALL REAR DRIVE SHAFT ASSEMBLY


    1. Install the rear drive shaft assembly LH and rear drive shaft assembly RH.

      Click here

  6. ADD DIFFERENTIAL OIL

    Click here