ДВИГАТЕЛЬ В СБОРЕ УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | V-BANK COVER SUB-ASSEMBLY | *2 | INLET NO. 1 AIR CLEANER |
| *3 | COOL AIR INTAKE DUCT SEAL | *4 | AIR CLEANER CAP WITH AIR CLEANER HOSE |
| *5 | NO. 2 FUEL VAPOR FEED HOSE | *6 | WIRE HARNESS |
| *7 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *8 | AIR CLEANER CASE SUB-ASSEMBLY |
| *9 | ENGINE UNDER COVER | *10 | REAR ENGINE UNDER COVER RH |
| *11 | REAR ENGINE UNDER COVER LH | *12 | FRONT SUSPENSION MEMBER BRACE |
| *13 | NO. 2 ENGINE UNDER COVER | *14 | UNION TO CHECK VALVE HOSE |
| *15 | NO. 2 VENTILATION HOSE | *16 | AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | HEATER INLET WATER HOSE | *2 | HEATER OUTLET WATER HOSE |
| *3 | NO. 2 FUEL VAPOR FEED HOSE | *4 | FUEL TUBE SUB-ASSEMBLY |
| *5 | FUEL PIPE CLAMP | *6 | NO. 3 FUEL HOSE |
| *7 | RADIATOR RESERVOIR TANK HOSE | *8 | NO. 2 RADIATOR HOSE |
| *9 | NO. 1 RADIATOR HOSE | *10 | WATER INLET SUB-ASSEMBLY |
| *11 | SUCTION HOSE | *12 | NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
| *13 | FUEL PIPE | *14 | NO. 1 FUEL PIPE |
| *15 | ENGINE ROOM ECU COVER | *16 | NO. 1 ENGINE ROOM RELAY BLOCK COVER |
| *17 | UNION TO CHECK VALVE HOSE | *18 | O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Compressor Oil ND-OIL8 | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | ENGINE WIRE | *2 | NO. 2 ENGINE WIRE |
| *3 | NO. 3 ENGINE WIRE | *4 | NO. 4 ENGINE WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | ENGINE WIRE | *2 | NO. 2 ENGINE WIRE |
| *3 | NO. 3 ENGINE WIRE | *4 | NO. 4 ENGINE WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | ENGINE ASSEMBLY WITH TRANSMISSION | *2 | FRONT CENTER FLOOR BRACE SUB-ASSEMBLY |
| *3 | FRONT LOWER BALL JOINT ASSEMBLY LH | *4 | FRONT LOWER SUSPENSION MEMBER PROTECTOR |
| *5 | FRONT SHOCK ABSORBER ASSEMBLY LH | *6 | FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY |
| *7 | FRONT UPPER NO. 2 SUSPENSION MEMBER | *8 | STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY |
| *9 | WIRE HARNESS | *10 | STRUT BAR BRACKET REINFORCEMENT LH |
| *11 | STRUT BAR BRACKET REINFORCEMENT RH | *12 | FRONT NO. 2 STABILIZER BRACKET LH |
| *13 | FRONT NO. 2 STABILIZER BRACKET RH | *14 | NO. 2 EARTH WIRE |
| *15 | FRONT SUSPENSION LOWER ARM ASSEMBLY LH | *16 | LEVER |
| *17 | SUSPENSION TOWER DAMPER | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | AUTOMATIC TRANSMISSION ASSEMBLY | *2 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
| *3 | ENGINE OIL LEVEL DIPSTICK GUIDE | *4 | EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst) |
| *5 | EXHAUST MANIFOLD SUB-ASSEMBLY RH (TWC: Front Catalyst) | *6 | FLYWHEEL HOUSING SIDE COVER |
| *7 | NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY | *8 | REAR ENGINE MOUNTING INSULATOR |
| *9 | NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE | *10 | REAR ENGINE MOUNTING MEMBER |
| *11 | STARTER ASSEMBLY | *12 | ENGINE OIL LEVEL DIPSTICK |
| *13 | O-RING | *14 | GASKET |
| *15 | WIRE HARNESS | *16 | REAR ENGINE MOUNTING BRACKET |
| *a | Black: x 1 Silver: x 5 |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY | *2 | FRONT ENGINE MOUNTING INSULATOR |
| *3 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *4 | FRONT DRIVE PLATE SPACER |
| *5 | REAR DRIVE PLATE SPACER | *6 | ENGINE ASSEMBLY |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ★ | Precoated part |