ДАТЧИК ДЕТОНАЦИИ УСТАНОВКА

PROCEDURE


  1. INSTALL KNOCK CONTROL SENSOR


    1. A01MXDFC02
      *A for Bank 1
      *B for Bank 2
      *a View A
      *b View B
      *c Top
      *d Engine Front
      *e Engine Rear
      A01MWAN Front
      A01MVAU View A
      A01MXUY View B

      Install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note

      Make sure that each knock control sensor is in the correct position.

    2. Connect the 2 knock control sensor connectors.

  2. INSTALL FUEL INJECTOR SEAL

    Click here