КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ СНЯТИЕ

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE CENTER NO. 4 ENGINE UNDER COVER

    Click here

  3. DRAIN ENGINE COOLANT

    Click here

  4. REMOVE INTAKE AIR SOUND CREATOR

    Tech Tips

    Only perform this procedure when replacement of the intake air sound creator is necessary.


    1. A01MXPX

      Loosen the hose clamp.

    2. Remove the bolt and intake air sound creator from the air cleaner cap with air cleaner hose.

  5. DISCONNECT NO. 2 VENTILATION HOSE


    1. A01MUYX

      Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

  6. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. A01MUIX

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disconnect the wire harness clamp from the air cleaner cap with air cleaner hose.

    3. A01MUT2

      Disconnect the No. 2 fuel vapor feed hose clamp from the air cleaner cap with air cleaner hose.

    4. A01MX6P

      Disconnect the union to check valve hose from the air cleaner cap with air cleaner hose (for RHD).

    5. A01MWCJ

      Release the 4 clamps.

    6. Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  7. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01MVAA

      Disconnect the throttle body with motor assembly connector.

    2. Remove the 4 bolts and throttle body with motor assembly from the intake air surge tank assembly.

    3. A01MXLNC01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

  8. REMOVE THROTTLE BODY GASKET


    1. Remove the throttle body gasket from the intake air surge tank assembly.