НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ УСТАНОВКА

PROCEDURE


  1. INSTALL ENGINE WATER PUMP ASSEMBLY


    1. A01MXBSC02
      A01MWAN Bolt A
      A01MVAU Bolt B
      A01MXUY Bolt C

      Install a new water pump gasket and the engine water pump assembly with the 16 bolts.

      Torque:
      Bolt A
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
      Bolt B and C
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note


      • Make sure that there is no oil on the threads of the bolts (A).

      • Be sure to replace the 2 bolts (C) with new ones or reuse them after applying adhesive.

        Adhesive
        Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
      Standard Length
      Item Length
      Bolt A 55 mm (2.17 in.)
      Bolt B, C 22 mm (0.87 in.)

  2. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY


    1. Install the No. 2 idler pulley sub-assembly and No. 2 idler pulley cover plate with the bolt.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  3. INSTALL WATER INLET


    1. Install a new No. 1 water inlet housing gasket and water outlet pipe O-ring.

    2. Install the water inlet with the 4 bolts and nut.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Be careful not to allow the No. 1 water inlet housing gasket and water outlet pipe O-ring to get caught between the parts.

    3. Connect the No. 2 water by-pass hose to the water inlet and slide the clip to secure it.

    4. Connect the No. 3 water by-pass hose to the water inlet and slide the clip to secure it.

    5. Connect the No. 4 water by-pass hose to the water inlet and slide the clip to secure it.

    6. Connect the No. 6 water by-pass hose to the water inlet and slide the clip to secure it.

    7. Connect the radiator reserve tank hose to the water inlet and slide the clip to secure it.

  4. INSTALL WATER PUMP PULLEY


    1. Temporarily install the water pump pulley with the 4 bolts.

    2. A01MYYRN01

      Using SST, hold the water pump pulley and tighten the 4 bolts.

      SST
      09960-10010   ( 09962-01000, 09963-00700 )
      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  5. INSTALL NO. 2 ENGINE COVER

    Click here

  6. INSTALL INJECTOR DRIVER

    Click here

  7. INSTALL NO. 1 ENGINE COVER

    Click here

  8. CONNECT NO. 2 RADIATOR HOSE

    Click here

  9. INSTALL NO. 1 RADIATOR HOSE

    Click here

  10. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

    Click here

  11. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

    Click here

  12. ADD ENGINE COOLANT

    Click here

  13. INSPECT FOR COOLANT LEAK

    Click here