BLACK OUT TAPE(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. REPAIR INSTRUCTION

    Click here

  2. INSTALL REAR DOOR LOWER OUTSIDE STRIPE LH

    Tech Tips

    When installing the rear door lower outside stripe, heat the rear door panel and rear door lower outside stripe using a heat light.

    Standard
    Item Temperature
    Rear Door Panel 40 to 60°C (104 to 140°F)
    Rear Door Lower Outside Stripe 20 to 30°C (68 to 86°F)

    Note

    Do not heat the rear door panel or rear door lower outside stripe excessively.


    1. A01VB4QE01

      Refer to the illustration to position a new rear door lower outside stripe.

      Reference Value
      Area Specified Condition
      A 2 to 4 mm (0.0787 to 0.157 in.)
      B 5 mm (0.1969 in.)

    2. Remove the release paper from the rear door lower outside stripe.

  3. INSTALL REAR DOOR OUTSIDE STRIPE LH

    Tech Tips

    When installing the rear door outside stripe, heat the rear door panel and rear door outside stripe using a heat light.

    Standard
    Item Temperature
    Rear Door Panel 40 to 60°C (104 to 140°F)
    Rear Door Outside Stripe 20 to 30°C (68 to 86°F)

    Note

    Do not heat the rear door panel or rear door outside stripe excessively.


    1. A01V7R1E01

      Refer to the illustration to position a new rear door outside stripe.

      Reference Value
      Area Specified Condition
      A 2 to 4 mm (0.0787 to 0.157 in.)
      B 5 mm (0.1969 in.)
      C 1.5 to 2.5 mm (0.0591 to 0.0984 in.)

    2. Remove the release paper from the rear door outside stripe.

  4. INSTALL DOOR WINDOW FRAME MOULDING CLIP

    Click here

  5. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR WEATHERSTRIP LH

    Click here

  7. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

    Click here

  8. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  9. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  10. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  11. INSTALL REAR DOOR GLASS RUN LH

    Click here

  12. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  13. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  15. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  18. CHECK POWER WINDOW CONTROL SYSTEM


    1. w/ Jam Prptection Function:

      Click here

    2. w/o Jam Prptection Function:

      Click here