REAR DOOR WINDOW FRAME MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DOOR WINDOW FRAME MOULDING CLIP


    1. Attach the 2 claws to install the door window frame moulding clip.

  2. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH

    Tech Tips

    When installing the rear door outside moulding, heat the rear door panel and rear door outside moulding using a heatlight.

    Standard
    Item Temperature
    Rear Door Panel 40 to 60°C (104 to 140°F)
    Rear Door Outside Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the rear door panel and rear door outside moulding excessively.


    1. Clean the rear door panel surface.


      1. Using a heat light, heat the rear door panelsurface.

      2. Remove the double-sided tape from the rear door panel surface.

      3. Wipe off any tape adhesive residue withcleaner.

    2. Install a new rear door outside moulding sub-assembly LH.


      1. Using a heat light, heat a new rear door outside moulding sub-assembly LH and the rear door panel surface.

      2. Remove the peeling paper from the face of the rear door outside moulding sub-assembly LH.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. A01V7TYC01
        *1 Protective Tape
        *2 Double-sided Tape

        Attach the clip and double-sided tape to install the rear door outside moulding sub-assembly LH.

        Tech Tips

        Press the rear door outside moulding sub-assembly LH firmly to install it.

  3. INSTALL REAR DOOR WEATHERSTRIP LH


    1. Install the rear door weatherstrip LH.

  4. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

    Click here

  5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  7. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  8. INSTALL REAR DOOR GLASS RUN LH

    Click here

  9. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  12. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  15. CHECK POWER WINDOW CONTROL SYSTEM


    1. w/ Jam Prptection Function:

      Click here

    2. w/o Jam Prptection Function:

      Click here