FRONT DOOR WINDOW FRAME MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  5. REMOVE FRONT DOOR ASSIST GRIP COVER LH

    Click here

  6. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

    Click here

  13. REMOVE FRONT DOOR WEATHERSTRIP LH

    A01VA0C

    1. Using a clip remover, remove the 2 clips.

    2. Detach the clip and Remove the front door weatherstrip LH so that the door window frame moulding clip can be removed.

  14. REMOVE DOOR WINDOW FRAME MOULDING CLIP

    A01VAG4

    1. Detach the 2 claws and remove the door window frame moulding clip.

  15. REMOVE FRONT DOOR WINDOW REAR FRAME MOULDING LH

    Tech Tips

    When removing window frame moulding, heat the front door panel and window frame moulding using a heat light.

    Standard
    Item Temperature
    Front Door Panel 40 to 60°C (104 to 140°F)
    Window Frame Moulding 20 to 30°C (68 to 86°F)

    Note

    Do not heat the front door panel or front door window rear frame moulding excessively.


    1. A01V9WLC01
      *1 Protective Tape
      *2 Double-sided Tape

      Put protective tape around the front door window rear frame moulding LH.

    2. Using moulding remover D, remove the double-sided tape to detach the clip and remove the front door window rear frame moulding LH.