HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE


  1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. Check the rear height control sensor sub-assembly LH.


      1. Connect 3 dry batteries of 1.5 V in series.

      2. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 1 (SHG) and terminal 2 (SHRR).

      3. Measure the voltage according to the value(s) in the table below.

        Note


        • Do not apply a voltage of more than 6 V.

        • Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.

        Standard Voltage
        Tester Connection Condition Specified Condition
        1 (SHG) - 2 (SHRR) High (+) Approx. 4.5 V
        Normal Approx. 2.5 V
        Low (-) Approx. 0.5 V
        A00YSYOC02
        *a

        Component without harness connected

        (Rear Height Control Sensor Sub-assembly LH)

        		 *b Low (-)
        *c Normal *d High (+)
        *e Stopper position at lowest vehicle height *f Stopper position at highest vehicle height

        If the result is not as specified, replace the height control sensor sub-assembly LH.