STOP LIGHT SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER


    1. Attach the 2 claws to install a new stop light switch mounting adjuster.

  2. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A01V8KEC01
      *1 Brake Pedal
      *2 Stop Light Switch Mounting Adjuster
      *3 Stop Light Switch Assembly

      Install the stop light switch assembly to the adjuster until the switch body slightly touches the brake pedal.

      Note

      Do not depress the brake pedal.

    2. A01V994C01
      *1 Shaft
      *2 0.5 to 2.6 mm (0.0197 to 0.102 in.)
      *3 Stop Light Switch Assembly

      Rotate the stop light switch assembly clockwise so that the clearance is between 0.5 and 2.6 mm (0.0197 to 0.102 in.) as shown in the illustration.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Do not depress the brake pedal.

    3. Check the stop light switch assembly clearance.

      Stop light switch clearance
      0.5 to 2.6 mm (0.0197 to 0.102 in.)

    4. Connect the connector to the stop light switch assembly.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here