REAR COMBINATION LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. A01PJBZ

      Install the rear turn signal light bulb to the rear turn signal light bulb socket.

  2. INSTALL REAR COMBINATION LIGHT LED


    1. A01PKS2C01
      *a Matchmark
      *b Unlock Position Mark
      *c Lock Position Mark

      Align the matchmark of the rear combination light LED to the unlock position mark, and then rotate the rear combination light LED clockwise until the lock position mark to install the rear combination light LED.

    2. Using a T20H "TORX" screwdriver, install the "TORX" screw.

  3. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH


    1. A01PIFKC01
      *a Matchmark
      *b Unlock Position Mark
      *c Lock Position Mark

      Align the matchmark of the rear turn signal light bulb socket to the unlock position mark, and then rotate the rear turn signal light bulb socket clockwise until the lock position mark to connect the rear turn signal light bulb socket.

    2. Connect the 2 connectors.

    3. A01PL0JC01
      A01PK3X Protective Tape

      Slide the rear combination light assembly LH towards the vehicle front to attach the pin and guide.

    4. Install the 2 bolts.