HIGH INTENSITY DISCHARGE HEADLIGHT BULB(for HID Headlight) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DISCHARGE HEADLIGHT BULB

    A01KAPIN01

    1. Set the discharge headlight bulb to the headlight unit.

    2. Lock the set spring in the order shown in the illustration to install the discharge headlight bulb to the headlight unit.

      Note

      Do not touch the discharge headlight bulb glass.

  2. INSTALL HEADLIGHT GASKET


    1. Install a new headlight gasket to the headlight light control ECU sub-assembly.

  3. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY


    1. A01KCMJ

      Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly socket.

      Note


      • Check that the headlight gasket is installed on the headlight light control ECU sub-assembly.

      • Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

      • Do not pull the headlight light control ECU sub-assembly with the socket connected.

    2. A01KB7Y

      Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to install the headlight light control ECU sub-assembly to the headlight unit.

    3. Connect the connector.

    4. for RHD:

      Install the washer tank with the clip.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here