AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the automatic headlight beam level control system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the vehicle battery voltage.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTC


    1. Check for DTCs.

      Click here

    2. Clear the DTCs.

      Click here

    3. Recheck for DTCs.

      Click here

      Result
      Proceed to
      DTC output does not reoccur
      DTC output reoccurs

    DTC output reoccurs

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    DTC output does not reoccur

  4. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      Fault is listed in Problem Symptoms Table

    Fault is listed in Problem Symptoms Table

    GO TO STEP 6 Click here

    Fault is not listed in Problem Symptoms Table

  5. OVERALL ANALYSIS AND TROUBLESHOOTING


    1. Operation Check.

      Click here

    2. Terminals of ECU.

      Click here

    3. Data List / Active Test.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  6. ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

    Result
    Proceed to
    NEXT

    NEXT

  7. CONFIRM TEST

    Result
    Proceed to
    NEXT

    NEXT

    END