WASHER NOZZLE ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT WASHER NOZZLE SUB-ASSEMBLY


    1. With the ignition switch turned to ON check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

      OK
      Washer fluid hits the windshield in the area shown in the illustration.

      If the result is not as specified, replace the washer nozzle sub-assembly.

      A00YR5ZC01
      *1 Ceramic Edge - -
      *a Upper Limit *b Standard
      *c Lower Limit *d Tolerance MAX
      *e Tolerance NOMINAL *f Tolerance MIN
      Standard
      Area Specified Condition Area Specified Condition
      A 247.2 mm (9.73 in.) B 91 mm (3.58 in.)
      C 6.77 mm (0.26 in.) D 256.7 mm (10.1 in.)
      E 91.7 mm (3.61 in.) F 188.6 mm (7.42 in.)
      G 274.2 mm (10.79 in.) H 404.9 mm (15.94 in.)
      I 194.1 mm (7.64 in.) J 231.9 mm (9.12 in.)
      K 182.3 mm (7.17 in.) L 76.4 mm (3.00 in.)
      M 84.7 mm (3.33 in.) - -