WASHER MOTOR REMOVAL

PROCEDURE


  1. REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

    Tech Tips

    Use the same procedure described for the LH side.

    Click here

  2. REMOVE FRONT FENDER LINER RH


    1. A01PLCPC01
      *a 90°

      Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    2. A01PJG8

      Remove the 2 screws.

    3. A01PKSW

      Remove the 4 grommets.

    4. A01PHNB

      Remove the 6 clips and front fender liner RH.

  3. DRAIN WASHER FLUID


    1. A01PH89

      Disconnect the washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

      Tech Tips

      Use a container to collect the washer fluid.

  4. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    1. A01PH3Z

      Disconnect the connector and hose.

    2. Pull out the windshield washer motor and pump assembly from the packing of the windshield washer jar assembly.

  5. REMOVE FRONT BUMPER COVER

    Click here

  6. REMOVE WASHER INLET SUB-ASSEMBLY


    1. A01PINM

      Remove the clip.

    2. Pull the washer inlet sub-assembly upward to remove it from the windshield washer jar assembly.

  7. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    1. w/o Headlight Cleaner System:


      1. Detach the 6 clamps.

        A01PIKAC01
        *a Guid - -
        A01PKQJ Bolt A01PHUR Connector

      2. Disconnect the connector.

      3. Remove the 3 bolts. Then detach guide and remove the windshield washer jar assembly.

    2. w/ Headlight Cleaner System:


      1. Detach the 6 clamps.

        A01PJ8IC01
        *a Guid - -

      2. Disconnect the 3 connectors.

      3. Remove the 3 bolts. Then detach guide and remove the windshield washer jar assembly.

  8. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    1. A01PIBU

      Pull out the level warning switch assembly in thedirection indicated by arrow in the illustration toremove it.

  9. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY (w/ Headlight Cleaner System)

    A01PIKY

    1. Remove the headlight cleaner motor and pump assembly.

  10. REMOVE HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)

    A01PKD2

    1. Detach the claw and remove the headlight cleaner control relay.