WIPER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.


  • The procedure listed below is for LHD vehicles.


  • Use the same procedure for the RH and LH sides.


  • The procedure listed below is for the RH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

    Click here

  5. REMOVE STEERING PAD ASSEMBLY

    Click here

  6. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  7. REMOVE STEERING COLUMN COVER

    Click here

  8. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A01V7KIC01
      *1 Protective Tape

      Disconnect the 2 connectors.

    2. Using a screwdriver, detach the claw and remove the windshield wiper switch assembly.

      Note

      Do not push the claw with excessive force as damage may occur.

      Tech Tips

      Tape the screwdriver tip before use.