WASHER NOZZLE REMOVAL

PROCEDURE


  1. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)

    Tech Tips

    Use the same procedure for both washer nozzle sub-assemblies.


    1. A01QTZ8C02
      A01QSVW Protective Tape

      Using a screwdriver, detach the 2 claws and remove the washer nozzle sub-assembly as shown in the illustration.

      Note

      Be careful not to damage the windshield.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01QP42

      Disconnect the washer nozzle sub-assembly from the washer hose.

      Note

      Washer nozzle sub-assemblies cannot be reused.

  2. REMOVE HOOD INSULATOR (w/ Heater)

    Click here

  3. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)

    Tech Tips

    Use the same procedure for both washer nozzle sub-assemblies.


    1. A01QT4NC01
      *A for LH Side
      *B for RH Side
      A01QRKS Washer Hose
      A01QOU0 Connector

      Disconnect the connector and washer hose.

    2. Detach the clamp.

    3. A01QS1ZC01
      A01QSVW Protective Tape

      Using a clip remover, detach the 2 claws and remove the washer nozzle sub-assembly as shown in the illustration.

      Note


      • Be careful not to damage the windshield.

      • Washer nozzle sub-assemblies cannot be reused.

      Tech Tips

      Tape the clip remover tip before use.