BACK DOOR CLOSER SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Back Door, Main Body or Smart Key* / Data List.


      • *: w/ Entry and Start System

    5. According to the display on the GTS, read the Data List.


      Body Electrical > Back Door > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Door Lock Status Back door condition signal Lock or Unlock

      Lock: Back door locked

      Unlock: Back door unlocked

      		 -
      Half Latch SW Latch switch signal ON or OFF

      ON: Back door lock motor open-latched

      OFF: Back door lock motor full-latched or half-latched

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Closer Position SW Sector switch signal ON or OFF

      ON: Back door lock center gear in center position

      OFF: Back door lock center gear not in center position

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Pawl Position Switch Pawl switch signal ON or OFF

      ON: Back door lock (pawl switch) on

      OFF: Back door lock (pawl switch) off

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Courtesy SW Back door courtesy switch signal ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      IG SW Ignition switch signal ON or OFF

      ON: Ignition switch ON

      OFF: Ignition switch off

      		 "OFF" is also displayed for this item when the ignition switch is ACC.
      #Codes The number of DTCs

      Min.: 0

      Max.: 255

      		 The number of DTCs -

      *: Refer to "CONSTRUCTION AND OPERATION"

      Click here


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Back Door Open Back door condition signal Permit or Prohibit

      Permit: Back door unlocked

      Prohibit: Back door locked

      		 -
      Back Door Open Handle SW Back door opener switch assembly signal ON or OFF

      ON: Back door opener switch assembly on

      OFF: Back door opener switch assembly off

      		 -

      Body Electrical > Smart Key > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Tr/B-Door Lock SW Back door opener switch assembly signal ON or OFF

      ON: Back door opener switch assembly on

      OFF: Back door opener switch assembly off

      		 -