SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF SWITCH ASSEMBLY)


    1. Remove the map light assembly (sliding roof switch assembly).

      Click here

    2. A00YUTUC01
      *a

      Component without harness connected

      (Map Light Assembly (Sliding Roof Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (GND3) - 5 (UP) UP switch is pressed Below 1 Ω
      1 (GND3) - 5 (UP) UP switch is not pressed 10 kΩ or higher
      1 (GND3) - 4 (DOWN) DOWN switch is pressed Below 1 Ω
      1 (GND3) - 4 (DOWN) DOWN switch is not pressed 10 kΩ or higher
      1 (GND3) - 3 (OPN) OPEN switch is pressed Below 1 Ω
      1 (GND3) - 3 (OPN) OPEN switch is not pressed 10 kΩ or higher
      1 (GND3) - 2 (CLS) CLOSE switch is pressed Below 1 Ω
      1 (GND3) - 2 (CLS) CLOSE switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the map light assembly (sliding roof switch assembly).

    3. Install the map light assembly (sliding roof switch assembly).

      Click here