RELAY(w/ Heated Windshield Defroster System) ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WIPER DEICER RELAY


    1. Remove the front wiper deicer relay from the engine room relay block.

  2. INSPECT FRONT WIPER DEICER RELAY (HWD NO. 1)


    1. A01PHM6C02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the front wiper deicer relay.

  3. INSPECT FRONT WIPER DEICER RELAY (HWD NO. 2)


    1. A01PHM6C02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the front wiper deicer relay.

  4. INSTALL FRONT WIPER DEICER RELAY


    1. Install the front wiper deicer relay to the engine room relay block.