RELAY(for Windshield Deicer) ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WIPER DEICER RELAY


    1. Remove the front wiper deicer relay from the engine room relay block.

  2. INSPECT FRONT WIPER DEICER RELAY

    A00YS43N09

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
      Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the front wiper deicer relay.

  3. INSTALL FRONT WIPER DEICER RELAY


    1. Install the front wiper deicer relay to the engine room relay block.