POWER WINDOW REGULATOR MOTOR(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart.

    Click here

PROCEDURE


  1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.

    2. A01V7UD

      Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

  2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

    Click here

  5. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

    Click here

  6. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. INSTALL DOOR ASSIST GRIP COVER LH

    Click here

  9. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL LH

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  12. CHECK POWER WINDOW

    Click here