POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.

Click here

PROCEDURE

INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
1. Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.
2. Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
  
  Tech Tips
  
  A new window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Click here
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Click here
INSTALL FRONT DOOR SERVICE HOLE COVER LH

Click here
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here
INSTALL FRONT DOOR ASSIST GRIP COVER LH

Click here
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Click here
INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

Click here
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

Click here
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)

Click here
CHECK POWER WINDOW
1. w/ Jam ProtectionFunction
  
  Click here
2. w/o Jam ProtectionFunction)
  
  Click here