POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) PRECAUTION


  1. IGNITION SWITCH EXPRESSIONS


    1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression Ignition Switch (Position) Engine Switch (Condition)
      Ignition Switch off LOCK Off (Lock)
      Ignition Switch ACC ACC On (ACC)
      Ignition Switch ON ON On (IG)
      Engine Start START On (Start)

  2. POWER WINDOW CONTROL SYSTEM PRECAUTIONS

    Note


    • The power window control system uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

      Click here

    • The power window control system prohibits the auto up and down function when the jam protection function malfunctions.

    • The power window control system prohibits the auto up and down function when the catch protection function malfunctions.

    • If the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) has been replaced with a new one, initialize the power window control system.

      Click here

    • If the front power window regulator motor assembly LH (for LHD) or front power window regulator motor assembly RH (for RHD) and door window regulator subassembly LH have been removed and installed, or if the power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

      Click here

    • The jam protection function and catch protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:


      1. A power window is being opened or closed while the vehicle is driven on a rough road.

      2. A power window is being opened or closed while the door is being opened or closed.

      3. The voltage changes abruptly.

    • Do not disconnect the battery while the Ignition Switch ON. Otherwise, DTC B2313 will be stored.

      Click here