FRONT CONSOLE BOX REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    1. A00YT9Z

      Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.

  2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (except Manual Transaxle)


    1. A00YT4Q

      Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.

  3. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


    1. A00YQROC01
      A00YW8G Protective Tape

      Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 9 clips and claw and remove the parking brake hole cover sub-assembly.

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A00YV9U

      Pull up the shift lever boot and disconnect it from the shift lever assembly.

    2. Apply protective tape as shown in the illustration.

    3. Using moulding remover B, detach the 12 clips and remove the upper console panel sub-assembly.

      A00YWQYC01
      A00YW8G Protective Tape - -

  5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (except Manual Transaxle)


    1. Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 12 clips and remove the upper console panel sub-assembly.

      A00YR9ZC01
      A00YW8G Protective Tape - -
    3. A00YRTJ

      Disconnect the connector.

  6. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH

    A00YWWP

    1. Detach the 2 clips and guide and remove the inner No. 1 instrument panel bracket cover LH.

  7. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

    A00YS2J

    1. Detach the 2 clips and guide and remove the inner No. 1 instrument panel bracket cover RH.

  8. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY


    1. A00YXJD

      Detach the 4 claws and remove the upper rear console panel sub-assembly.

  9. REMOVE CONSOLE BOX CARPET


    1. A00YX9I

      Remove the console box carpet.

  10. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A00YVJ8C01
      A00YW8G Protective Tape.

      Apply protective tape as shown in the illustration.

    2. Using moulding remover B, detach the 5 clips and remove the lower center instrument panel finish panel.

  11. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY


    1. Remove the 2 screws.

    2. Remove the 4 bolts and rear console box sub-assembly.

      A00YVRB