UPPER INSTRUMENT PANEL REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL GLOVE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)


    1. A00YU4VC01
      *1 Stopper

      Push the stopper and insert the glove compartment door lock cylinder assembly to the glove compartment door assembly to install it.

  2. INSTALL NO. 4 INSTRUMENT PANEL CUSHION

    A00YQW9

    1. Install a new No. 4 instrument panel cushion using adhesive or double-sided tape in the location shown in the illustration.

  3. INSTALL NO. 1 INSTRUMENT PANEL CUSHION


    1. Install 2 new No. 1 instrument panel cushions in the location shown in the illustration.

      A00YVQ8

  4. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    for Single Type Airbag:

    Click here

    for Dual Type Airbag:

    Click here

  5. INSTALL NO. 2 INSTRUMENT PANEL WIRE

    for Single Type Airbag:

    Click here

    for Dual Type Airbag:

    Click here

  6. INSTALL CENTER INSTRUMENT PANEL REGISTER CONNECTOR


    1. Install the center instrument panel register connector with the 2 screws <A>.

  7. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)

    Click here

  8. INSTALL NO. 2 INSTRUMENT PANEL WIRE (w/ Speaker)


    1. Attach the 8 wire harness clamps to install the No. 2 instrument panel wire.

  9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Tech Tips

    Use the same procedure to install the No. 2 instrument panel register assembly on the other side.


    1. Attach the 3 claws to install the No. 2 instrument panel register assembly.

  10. INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY


    1. Install the No. 2 heater to register duct sub-assembly with the 2 screws <A>.

  11. INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY


    1. Install the No. 1 heater to register duct sub-assembly with the 3 screws <A>.

  12. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A00YRBN

      Attach the 2 clips to install the instrument cluster finish panel garnish.

  13. INSTALL BOX BOTTOM MAT


    1. Install the box bottom mat.