BLOWER RESISTOR INSPECTION

PROCEDURE


  1. INSPECT BLOWER RESISTOR


    1. A00YRLOC05
      *A for LHD
      *B for RHD
      *a

      Component without harness connected

      (Blower Resistor)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance for LHD
      Tester Connection Condition Specified Condition
      4 (LO) - 1 (HI) Always 3.12 to 3.60 Ω
      2 (M1) - 1 (HI) Always 1.45 to 1.67 Ω
      3 (M2) - 1 (HI) Always 0.52 to 0.60
      Standard Resistance: for RHD
      Tester Connection Condition Specified Condition
      1 (LO) - 4 (HI) Always 3.12 to 3.60 Ω
      3 (M1) - 4 (HI) Always 1.45 to 1.67 Ω
      2 (M2) - 4 (HI) Always 0.52 to 0.60

      If the result is not as specified, replace the blower resistor.